1. <dd id="h82u4"><center id="h82u4"></center></dd>
      
      
        <dd id="h82u4"></dd>

          1. <span id="h82u4"></span>

            新聞中心

            • 新聞中心
            您現在的位置:主頁 > 新聞中心 >

            新聞中心

            濟南燈箱制作需要完美的工藝與包裝

            頁面更新時間:2015-05-21 11:07 來源:未知 作者:admin 點擊:

            1、剪邊

            1, cut edge

            電鍍結束后,還要將半成品上的余量切掉。把濟南燈箱制作半成品放在剪扳機的合適位置,在上面蓋一張紙板后再剪切,以免把表面的電鍍劃傷。

            After plating, will cut off the excess of semi-finished products. The Ji'nan light box production of semi-finished products on the appropriate position of the trigger, the above cover a cardboard after shear, lest the surface of the plating scratches.

            2、選擇裝飾板

            2, choose decorative plate

            后面的裝飾板,是放置、安裝標牌不可缺少的組成部分。它能使標牌更加完美。

            The rear decorative plate is the indispensable part of the placement and installation of the signs. It can make the sign more perfect.

            3、粘板

            3, sticky plate

            在選好的裝飾板上,量出并標記好要粘貼的位置。

            In the selected trim panel, the amount of the location and mark the location of the paste.

            在裝飾板上粘兩條雙面膠帶,在四個角和中間位置擠些玻璃膠,撕掉雙面膠帶上的保護紙,把不銹鋼板粘在裝飾板上,用力壓緊,平放5分鐘以上。

            In the decorative board stick two strips of double-sided adhesive tape, in the four corners and the middle position of the squeeze some glass glue, double-sided adhesive tape protective paper tear, the stainless steel plate sticking decorative board, hard pressed, flat for more than 5 minutes.

            4、保管

            4, custody

            把已完成的作品,裝入包裝袋,妥然保管好。

            Put the finished work into the package, and keep it safe..

            真人性视频全过程视频_bdsm另类sm呦女_少妇泬出白浆18P_免费永久观看美女裸体网站